Overseas exchange

About this chapter

This chapter explains the policies and procedures for overseas exchange for undergraduate students in the following degrees:

• Bachelor of Design in Architecture

• Bachelor of Design Computing

Exchange in the Bachelor of Design in Architecture

• The faculty may approve international exchange for qualified students who have completed at least one full year of study. All students must complete the final semester of third year at the University of Sydney. Exchange will not be considered for honours.
• Exchanges may be for one semester only. Students must apply through the Study Abroad and Exchange unit of the International Office. Each student€™s program must be approved in consultation with the Degree Program Director.
• Exchange students are required to enrol in a full-time load at the University of Sydney whilst on exchange, and will incur the tuition costs associated with that load. No tuition costs will be incurred with the partner University.
• Specially designated units of study will be recorded on the students€™ transcript. A result of €˜R€™ for €˜Satisfied Requirements€™ will be recorded by the University against each successfully completed unit of study. The transcript of the exchange University will be the official detailed record of exactly what was completed during the exchange. Exchange results will not count against a student€™s Weighted Average Mark.
• For more information please contact either the Study Abroad and Exchange Office or the Faculty of Architecture, Design and Planning Student Administration Centre

Exchange in the Bachelor of Design Computing

• The faculty may approve international exchange for qualified students who have completed at least one full year of study. All students must complete the final semester of third year at the University of Sydney. Exchange will not be considered for honours.
• Exchanges may be for one or two semesters. Students must apply through the Study Abroad and Exchange unit of the International Office. Each student€™s program must be approved in consultation with the program director of the degree.
• Exchange students are required to enrol in a full-time load at the University of Sydney in each semester of exchange, and will incur the tuition costs associated with that load. No tuition costs will be incurred with the partner university.
• Exchange units should be taken as part of the degree, satisfying the requirements that would normally be covered at this university during the same period. Exchange should not be in addition to the degree requirements.
• Specially designated units of study will be recorded on the transcript. A result of 'R' for 'Satisfied Requirements' will be recorded by this university against each successfully completed unit. The transcript of the exchange university will be the official detailed record of exactly what was completed during the exchange. Exchange results will not count towards a student€™s Weighted Average Mark.
• The exchange units for enrolment at the University of Sydney, to be approved with the program director, shall be selected from the following table.
• For advice on exchanges please contact the Student Adviser in the Faculty of Architecture, Design and Planning Student Administration Centre.