Resolutions of the Faculty
The composition of faculties and University Schools is provided by the University of Sydney (Governance of Faculties and University Schools) Rule 2016 (289KB PDF).
Resolutions of the Faculty of Engineering and Information Technologies for coursework awards
These resolutions apply to all undergraduate and postgraduate coursework award courses in the Faculty, unless specifically indicated otherwise. Students enrolled in postgraduate research awards should consult the resolutions for their course. These resolutions must be read in conjunction with applicable University By-laws, Rules and policies including (but not limited to) the University of Sydney (Coursework) Rule 2014 (the 'Coursework Rule'), the Coursework Policy 2014 (the 'Coursework Policy'), the resolutions for the course of enrolment, the University of Sydney (Student Appeals against Academic Decisions) Rule 2006 (as amended), the Academic Honesty in Coursework Policy 2015 and the Academic Honesty Procedures 2016. Up to date versions of all such documents are available from the Policy Register: http://sydney.edu.au/policies.
Part 1: Course Enrolment
1 Enrolment Restrictions
(1)
Except where explicitly listed in a Faculty recommended program of enrolment, or with the permission of the Dean or delegate, an undergraduate student shall satisfy the following enrolment requirements.
(d)
A student shall enrol in lower year level core units of study as a priority above any higher year level units of study irrespective of meeting any prerequisite requirements of the higher year units.
(e)
Any student subject to the requirements of the Professional Engagement Program (PEP) shall successfully complete each required stage of the Program prior to enrolling in units that could extend their completed credit points past the specified level for that stage.
2 Transferring Between Streams or Degrees
(1)
Students admitted to specific postgraduate degrees or streams wishing to transfer between degrees or streams managed by the Faculty need to apply to the Faculty and obtain the approval of the Dean (or delegate). Students will be assessed based on their progress in their current degree or stream and must be able to show that they meet the criteria that apply to commencing students.
3 Time Limits
(1)
The provisions of the Coursework Rule apply to the time limits for undergraduate and postgraduate programs, unless otherwise stated in the course resolutions; with the following clarification:
(a)
For a course within an embedded sequence, the time limit commences at the time of first enrolment in the sequence.
4 Suspension, Discontinuation and Lapse of Candidature
0.
The Coursework Rule and Coursework Policy specify the conditions for suspending or discontinuing candidature, and return to candidature after these events. The Rule and Policy also define the circumstances when candidature is deemed to have lapsed. Students seeking to suspend, discontinue or apply for a return to candidature after a lapse must apply to the Dean of Engineering and Information Technologies or their delegate for permission, supplying detailed reasons and evidence to support the request.
5 Credit for Previous Study
(1)
Conditions for the granting of credit for previous study are in accordance with the Coursework Rule and Policy, except:
(a)
the maximum credit that may be granted to the Bachelor of Engineering Honours degree, Bachelor of Engineering Honours combined degrees, Bachelor of Advanced Computing degree or Bachelor of Advanced Computing combined degrees is 96 credit points;
(b)
the maximum credit that may be granted to the Bachelor of Computing or Bachelor of Project Management is 48 credit points; and
(c)
credit for prior learning at the University of Sydney at postgraduate level may be given subject to the approval of the Faculty and to the following conditions:
(i)
where no award has been conferred, credit may be transferred in full to the Graduate Diploma and Master degree;
(d)
credit for prior learning at postgraduate level at an external institution recognised by the University of Sydney may be granted as follows:
(i)
where no award has been conferred credit to a maximum of 50 percent of the degree may be approved, provided units of study have been completed at credit average and are equivalent to units of study offered under the degree being taken;
(ii)
where an award has been conferred credit to a maximum of 12 credit points may be approved provided units of study have been completed at credit average and are equivalent to units of study offered under the degree being taken;
Part 2: Unit of Study Enrolment
6 Cross-institutional Study
(1)
Provided permission has been obtained in advance, the Dean (or delegate) may permit a student to complete a unit of study at another institution and have that unit credited to the student's course requirements, provided that:
(a)
the resolutions of the student's course of enrolment do not specifically exclude cross-institutional study; and either
(b)
the unit of study content is not taught in any corresponding unit of study at the University; or
(c)
the student is unable, for good reason, to attend a corresponding unit of study at the University.
7 International Exchange
0.
The Faculty encourages students to participate in international exchange programs, except where specified otherwise in the resolutions for a particular course. Students must apply to the Head of the relevant School of Engineering and Information Technologies to obtain approval for their planned enrolment while on exchange. This guarantees that the units completed externally will be correctly matched to the core requirements of their Course. International exchange must not exceed 12 months / 48cp and must not be approved where it would result in less than 50% of the normal course requirements being completed at the University of Sydney.
Part 3: Studying and Assessment
8 Attendance
(1)
Students are required to be in attendance at the correct time and place of any formal or informal examinations. Non attendance on any grounds insufficient to claim special consideration will result in the forfeiture of marks associated with the assessment. Participation in a minimum number of assessment items may be a requirement of any unit of study.
(2)
Students are expected to attend a minimum of 90 percent of timetabled activities for a unit of study, unless granted exemption by the Dean or Head of School most concerned. The Dean or Head of School most concerned may determine that a student fails a unit of study because of inadequate attendance. Alternatively, at their discretion, they may set additional assessment items where attendance is lower than 90 percent.
9 Special Consideration for Illness, Injury or Misadventure
0.
Special consideration is a process that affords equal opportunity to students who have experienced circumstances that adversely impact their ability to adequately complete an assessment task in a unit of study. The Coursework Policy provides full details of the University policy and procedures.
10 Concessional Pass
11 Re-assessment
Part 4: Progression, Results and Graduation
12 Satisfactory Progress
0.
The Faculty will monitor students for satisfactory progress towards the completion of their award course. In addition to the common triggers used to identify students not meeting academic progression requirements (as defined by the Progression requirements of the Coursework Rule and Coursework Policy, students must pass any unit of study identified in the course resolutions as being critical to progression through the course.
13 Award of the Bachelor's Degree with Honours
0.
Honours is available to students as either appended honours or integrated honours. Admission, requirements and award for the honours courses are in accordance with the relevant course resolutions.
14 Faculty of Engineering and Information Technologies Specific Weighted Average Mark Indicators.
| Formula |
|---|
| WAM=Σ (CPi x Mi) / Σ (CPi) |
| Formula | ||
|---|---|---|
| EIHWAM=Σ(Wi x CPi x Mi) / Σ(Wi x CPi) |
(a)
Wi is the weighting given by 0 for 1000 level units of study, 2 for 2000 level units, 3 for 3000 level units and 4 for 4000 level or above units. Thesis units of study are given a double weighting of 8.
0.
All attempts at units of study are included except for: units of study assessed on a pass/fail basis; units of study with a grade of DC; and credited units of study from other institutions. The mark used for units of study with a grade of AF or DF is zero.
15 University Medal
0.
A student who has qualified for the award with first class honours and has an EIHWAM of 85 or above, and who has demonstrated excellence in their honours thesis will be considered for the award of a University Medal. The Medal is awarded at the discretion of the Dean or relevant Associate Dean, after the recommendation of the relevant Head of School, to the highest achieving students who in the opinion of the Faculty have an outstanding academic record, in accordance with the Coursework Rule and Coursework Policy.
Part 5: Other
16 Transitional Provisions
(1)
These resolutions apply to students who commenced their candidature on or after 1 January, 2019.