Overseas exchange
About this section
This section explains the policies and procedures for overseas exchange for undergraduate students in the following degrees:
- Bachelor of Design in Architecture
- Bachelor of Design Computing.
Exchange in the Bachelor of Design in Architecture
- The faculty may approve international exchange for qualified students who have completed at least one full year of study. All students must complete the final semester of third year at the University of Sydney. Exchange will not be considered for honours.
- Exchanges may be for one semester only. Students must apply through the Study Abroad and Exchange unit of the International Office. Each student's program must be approved in consultation with the Degree Program Director.
- Exchange students are required to enrol in a full-time load at the University of Sydney whilst on exchange, and will incur the tuition costs associated with that load. No tuition costs will be incurred with the partner University.
- Specially designated units of study will be recorded on the students' transcript. A result of 'R' for 'Satisfied Requirements' will be recorded by the University against each successfully completed unit of study. The transcript of the exchange University will be the official detailed record of exactly what was completed during the exchange. Exchange results will not count against a student's Weighted Average Mark.
- For more information please contact either the Study Abroad and Exchange Office or the Faculty of Architecture, Design and Planning Student Administration Centre.
Unit of study | Credit points | A: Assumed knowledge P: Prerequisites C: Corequisites N: Prohibition | Session |
---|---|---|---|
Bachelor of Design in Architecture exchange units |
|||
Year 2 core units of study |
|||
BDES2610 Architecture Exchange Studio 201 |
6 |
Note: Department permission required for enrolment |
Semester 1 |
BDES2613 Architecture Exchange Technologies 2 |
6 |
Note: Department permission required for enrolment |
Semester 1 |
BDES2612 Architecture Exchange Communications 2 |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
BDES2620 Architecture Exchange Studio 202 |
6 |
Note: Department permission required for enrolment |
Semester 2 |
BDES2621 Architecture Exchange History/Theory 2 |
6 |
Note: Department permission required for enrolment |
Semester 2 |
Year 2 elective units of study |
|||
BDES2615 Architecture Exchange Elective 2A |
6 |
Note: Department permission required for enrolment |
Semester 1 |
BDES2616 Architecture Exchange Elective 2B |
6 |
Note: Department permission required for enrolment |
Semester 2 |
BDES2617 Architecture Exchange Elective 2C |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
Year 3 core units of study |
|||
BDES3610 Architecture Exchange Studio 301 |
6 |
Note: Department permission required for enrolment |
Semester 1 |
BDES3611 Architecture Exchange History/Theory 3 |
6 |
Note: Department permission required for enrolment |
Semester 1 |
BDES3612 Architecture Exchange Communications 3 |
6 |
Note: Department permission required for enrolment |
Semester 1 |
Year 3 elective units of study |
|||
BDES3615 Architecture Exchange Elective 3A |
6 |
Note: Department permission required for enrolment |
Semester 1 |
Exchange in the Bachelor of Design Computing
- The faculty may approve international exchange for qualified students who have completed at least one full year of study. All students must complete the final semester of third year at the University of Sydney. Exchange will not be considered for honours.
- Exchanges may be for one or two semesters. Students must apply through the Study Abroad and Exchange unit of the International Office. Each student's program must be approved in consultation with the program director of the degree.
- Exchange students are required to enrol in a full-time load at the University of Sydney in each semester of exchange, and will incur the tuition costs associated with that load. No tuition costs will be incurred with the partner university.
- Exchange units should be taken as part of the degree, satisfying the requirements that would normally be covered at this university during the same period. Exchange should not be in addition to the degree requirements.
- Specially designated units of study will be recorded on the transcript. A result of 'R' for 'Satisfied Requirements' will be recorded by this university against each successfully completed unit. The transcript of the exchange university will be the official detailed record of exactly what was completed during the exchange. Exchange results will not count towards a student's Weighted Average Mark.
- The exchange units for enrolment at the University of Sydney, to be approved with the program director, shall be selected from the following table.
- For advice on exchanges please contact the Student Adviser in the Faculty of Architecture, Design and Planning Student Administration Centre.
Unit of study | Credit points | A: Assumed knowledge P: Prerequisites C: Corequisites N: Prohibition | Session |
---|---|---|---|
Bachelor of Design Computing exchange units |
|||
Year 2 core units of study |
|||
Senior units of study |
|||
DECO2670 Exchange Design Computing Studio 2 |
12 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO2660 Exchange Collaborative Virtual Environs |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
Year 2 elective units of study |
|||
Senior units of study |
|||
DECO2664 Design Comp Exchange Tech Elective 2A |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO2665 Design Comp Exchange Tech Elective 2B |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO2666 Design Comp Exchange AES Elective 2A |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO2667 Design Comp Exchange AES Elective 2B |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO2668 Design Comp Exchange Elective 2A |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO2669 Design Comp Exchange Elective 2B |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
Year 3 core units of study |
|||
Senior units of study |
|||
DECO3660 Exchange Design Computing Studio 3 |
12 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
Year 3 elective units of study |
|||
Senior units of study |
|||
DECO3662 Design Computing Exchange Elective 3A |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO3663 Design Computing Exchange Elective 3B |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |
DECO3664 Design Computing Exchange Elective 3C |
6 |
Note: Department permission required for enrolment |
Semester 1 Semester 2 |